Tamko Evergrain Manuel d'utilisateur télécharger pdf

EG 1•2•3 Hidden Fastener

Installation Instructions

Place rst deck board on frame joists in the location where it will be

installed. Once in position, ip board over being careful not to move the

board side to side from position. Install with board screws to the deck

board directly above each joist. Make sure spacing tabs are pointing

downward.

CAUTION: Use low torque setting to avoid spinout.

IMPORTANT: EG 1•2•3 PRODUCT INFORMATION

TOOLS & MATERIALS NEEDED

STEP 1.

INSTALLING FIRST FASTENERS

STEP 3.

INSTALLING FIRST BOARD

Start installation at the house and work toward the outer edge of the

deck. Start by attaching a fastener to the ledger board with spacing

tabs pointing downward. Use a joist screw through hole B while

allowing hole A to extend over the ledger board as shown. (These will

be afxed at a later step.)

Power screw gun with

ratcheting torque setting

1 1/2" JOIST Screws

(included in packaging)

EG 1-2-3 Fasteners

(included in packaging)

Flip rst board back over; align the fastener with framing joist, and

install a joist screw through hole A and into the deck frame.

Attach board edge closest to house by installing a board screw through

hole A of each fastener up into the bottom of the deck board. (Secure

the fasteners installed in Step 1.)

NOTE: It is only required to install a board screw into the fastener

from underneath the board on the FIRST and LAST board.

STEP 2.

POSITION FASTENERS

STEP 4.

COMPLETING INSTALLATION OF FIRST BOARD

• The EG 1-2-3 Hidden Fastener has been designed to work specically and exclusively with the EverGrain 1" x 6" and 2" x 6" decking proles.

Usage of the fastener with any other product has not been tested and is not recommended.

• Make safety of the workplace the prime consideration. Always wear the proper protective clothing and safety equipment.

• Framing supports should be straight and level with each other to ensure proper installation and an even surface.

• EG 1-2-3 Hidden Fasteners must be installed in accordance with the installation instructions. Deviation from these instructions may result in

unsatisfactory performance and may exclude coverage of your EG 1-2-3 Hidden Fastener under the limited warranty.

3/4" BOARD Screws

(included in packaging)

1 2 3 4

EG 1•2•3 Hidden Fastener 1

Résumé du contenu

Page 1 - EG 1•2•3 Hidden Fastener

EG 1•2•3 Hidden Fastener Installation InstructionsPlace rst deck board on frame joists in the location where it will be installed. Once in position,

Page 2

EG 1•2•3 Hidden Fastener Installation InstructionsPlace deck board in desired location to be installed. Flip deck board over being careful not to move

Page 3

EG 1•2•3 Hidden Fastener Installation Instructions IMPORTANT EG 1•2•3 PRODUCT INFORMATIONTOOLS & MATERIALS NEEDED• The EG 1-2-3 Hidden Fastener h

Page 4

EG 1•2•3 Hidden Fastener Installation InstructionsPlace fastener tight against board edge with spacing tabs pointing downward. Slide fastener along ed